Intelligente temperatuur | vochtsensor, 230 VAC

€ 120,42

Envoi

10depuis 10 janv.. '25, 07:40

Description

These intelligent multifunctional built-in sensors operate directly on 230 V mains voltage and have an adjustable temperature, relative humidity and light sensor on board. Their algorithm controls a single analogue/modulating output based on the measured temperature and relative humidity. The output can be used to directly control an EC fan or a valve actuator. The output type can be selected between 0-10 VDC / 0-20 mA / 0-100% PWM. All data is also available via Modbus RTU. The firmware can be easily updated thanks to the bootloader function. And thanks to the integrated ambient light sensor, the ventilation system can be optimised depending on the occupancy of the room. The light intensity of the three integrated LEDs for status indication can be adjusted via Modbus RTU.

Temperature and humidity measurement in 1 sensor with 1 smart output
The most important comfort parameters for a pleasant feeling indoors are temperature and humidity. With this sensor, both parameters are measured and one control signal is calculated based on both measured values. With its smart algorithm, you have one smart output with which you can directly control your EC fan or valve drive or via a speed controller you can control an AC motor. Easy to connect to 230 VACThis FCTH sensor is available in different versions depending on the required power supply. The handy thing about this FCTH8 version is that you can connect it directly to the 230 V mains. No need for a separate power supply. Additional light sensor
The Sentera room sensors are already equipped with a light sensor that measures the ambient light. You can save and retrieve the measured values. And in later, or existing Modbus-compatible, applications you will even be able to adapt the algorithm according to the ambient light .Permanent visual control
Thanks to the integrated and dimmable LEDs, you can see at a glance whether the measured value is acceptable, or whether it is in the warning zone or even in the danger zone . Not every situation is the same, so you determine the values at which the LEDs change colour.Flush-mounted or surface-mounted
You don't have to choose. The sensors from the Fxxx series are all suitable for both flush-mounted and surface-mounted installationReady to use
This sensor does not require any configuration. Once installed, it is ready to use. The default settings are sufficient for most applications. If necessary, the settings can be adjusted via Modbus RTU. For example, a different output type can be selected to make it compatible with other devices: 0-10 VDC / 0-20 mA / 0-100 % PWM / Modbus RTU. The light intensity of the LEDs for status indication is also adjustable. The Modbus register map provides a complete overview of all adjustable settings.Everything in proportion
You determine the " proportions " between the different measured values. By this we mean that you determine whether and to what extent the different measured values weigh in the final result. In this instruction video you can see how that works. You can also switch them off. So if you want, for example, only the humidity measurement to be taken into account, but not the temperature, then that can be perfectly set via Modbus RTU.