Atlas Copco FD60 Luchtdroger (Bj.2016) 230Volt / 3600L/min

• kan gekocht worden in combinatie met Atlas Copco GA15 compressor*

Amper van nieuw te onderscheiden!

Komt met Nederlandstalige Documenten en Handleiding

Incl. 1inch Flexibele Darmen om deze op je persluchtnetwerk aan te sluiten.

Specs:
60°C maximum inlet conditions at full flow (ambient/inlet)
127 CFM inlet flow with pressure dew point of 3°C/37.4°F
3.2 PSI pressure drop at full flow
0.63kW power consumption
189 PSI maximum working pressure
R 1 compressed air connections
Integrated liquid and water separator
Electronic no-loss condensate drain
Fan switch
Hot gas bypass valve to prevent freezing at lower loads
Refrigerant separator
Single electrical connection


The Atlas Copco FD 60 Refrigerated Air Dryer uses a refrigerant circuit and heat exchanger to pre-cool air, refrigerate it to condense out moisture vapor, and then re-heat the air to prevent pipe sweating downstream. The compact brazed plate or aluminum heat exchanger was designed specifically to provide optimal pre-cooling and the lowest possible pressure drop. The electronic no-loss condensate drain comes with a level sensor to open the drain only when needed, preventing unnecessary loss of compressed air.

An Elektronikon Alpha controller displays the pressure dew point and relative humidity. The unit includes a remote alarm and start/stop control through voltage-free contact. FD dryers use CFC-free refrigerants (R134A and R410A) with an ozone depletion potential (ODP) of zero. Capillary tubes cope with all conditions, with no moving parts. A condenser with louvered fin technology improves performance in dusty environments. weeg niet te veel en kan makkelijk met 2 personen ingeladen worden. Af te halen te Herselt na afspraak